![]() ![]() To verify, take off the motor hood and find the green circuit board called the motor controller. In most cases this means you need a new controller. If everything on the display console is working correctly then we know it is either a problem with the wires from the console to the controller or the controller itself. SOURCE: Nordic Track Ifit Treadmill has power but walking pad not working ![]() Nordictrack space saver treadmill driver#Use a non-metallic phillips head screw driver to adjust the potentiometer either clockwise for faster or counterclockwise for slower. On the control pwb there will be a yellow/orange potentiometer. ![]() Once inside the cover locate the control pwb. Should be 3 screws in the rear of the cover and 2 screws on the bottom of the unit. To access the control pwb open the hood cover. If it is not then it will need to be adjusted using a potentiometer on the control pwb. The display will show a speed on the console and should be within. The machine should then be running at its maximum speed (either 10 or 12 mph depending on the unit) If you need to calibrate the speed you will need to press and hold the speed up button on the console until the display reads 85. The unit should go all the way to the top and return to the bottom when completed. If you are trying to calibrate the incline you just need to hit the incline up button and the machine will do an incline calibration. With the safety key out, hold the stop and speed up arrow at the same time while inserting the key. Hello there, The calibration mode for a nordictrack is as follows. SOURCE: Calibration Mode for nordic track treadmill model ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |